[squid-users] Maxconn Parameter behaviour with NAT

[Matus UHLAR - fantomas]

On 14.01.16 16:58, Murat Balkan wrote:
>I want to limit the users with the Maxconn parameters. But the users are
> NATed behind a public IP address.  Is squid just looking at the IP address
> or can it also use the username to figure out if it should apply the
> maxconn?

maxconn uses clients' addresses as described. That means, when more users
are NATted behind one IP, squid can't differ between them.

you can use maxuser for their usernames as they are autenticated to squid.

-- 
Matus UHLAR - fantomas, uhlar at fantomas.sk ; http://www.fantomas.sk/
Warning: I wish NOT to receive e-mail advertising to this address.
Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu.
42.7 percent of all statistics are made up on the spot.