[squid-users] subnet forward

[Marcus Kool]

to be sure that the link speed and duplex is OK, you need to look at both sides.

Marcus

On 09/07/2016 01:01 PM, Pol Hallen wrote:
>> Since you have an ancient version of Squid I am assuming that you also
>> have ancient hardware.
>
> :-)
>
> NIC are not so ancient :-) hw also..
>
> Settings for eth0:
>     Supported ports: [ TP MII ]
>     Supported link modes:   10baseT/Half 10baseT/Full
>                             100baseT/Half 100baseT/Full
>                             1000baseT/Half 1000baseT/Full
>     Supported pause frame use: No
>     Supports auto-negotiation: Yes
>     Advertised link modes:  10baseT/Half 10baseT/Full
>                             100baseT/Half 100baseT/Full
>                             1000baseT/Half 1000baseT/Full
>     Advertised pause frame use: Symmetric Receive-only
>     Advertised auto-negotiation: Yes
>     Link partner advertised link modes:  10baseT/Half 10baseT/Full
>                                          100baseT/Half 100baseT/Full
>                                          1000baseT/Full
>     Link partner advertised pause frame use: Symmetric
>     Link partner advertised auto-negotiation: Yes
>     Speed: 1000Mb/s
>     Duplex: Full
>     Port: MII
>     PHYAD: 0
>     Transceiver: internal
>     Auto-negotiation: on
>     Supports Wake-on: pumbg
>     Wake-on: g
>     Current message level: 0x00000033 (51)
>                    drv probe ifdown ifup
>     Link detected: yes
>
> Pol
> _______________________________________________
> squid-users mailing list
> squid-users at lists.squid-cache.org
> http://lists.squid-cache.org/listinfo/squid-users